Medea Beauty Setup Guide

1. M-100 Medea Beauty Wand 

Setup

  • Charge fully using the provided USB cable before first use (typically 2–3 hours).
  • Once charged, press the power button briefly to cycle through light modes (red, blue, combined), indicated by an LED light.

Usage

  1. Cleanse your skin thoroughly before use.
  2. Select the desired light mode:
    • Red: collagen stimulation
    • Blue: targets acne/or bacteria
    • Combined: both effects
    • Apply dry — move the wand slowly (1–2 cm above skin or lightly touching) in circular or linear motions.
  1. Sesssion length: ~2 minutes per area; 10–15 minutes total per session.
  2. Frequency: 3–4× per week; daily is okay if tolerance is good.

Aftercare

  • Apply serums (hyaluronic acid, peptides) post-session.
  • Finish with a moisturizer and, during daytime, SPF 30+.

2. M-300 Eye Mask 

Setup

  • Connect USB cable and charge until LED indicates full battery.
  • Power on and cycle through modes with the control button.

Usage

  1. Cleanse around the eye area and pat dry.
  2. Select mode:
    • Red light: reduces puffiness, boosts circulation
    • Combined (if available) for added benefits
  3. Wear the mask, adjusting the elastic strap to sit comfortably on the eye zone.
  4. Session length: 10 minutes.
  5. Frequency: Daily or every other day — ideal during mornings or before bedtime.

Aftercare

  • Gently apply an eye serum (retinol or peptide-based).
  • Follow with a hydrating eye cream.

3. M-200 Portable LED Red Light Soft Silicone Mask 

Setup

  • Fully charge the internal battery using the provided USB-C cable.
  • Use the control panel or remote to power on and choose the light mode.

Usage

  1. Clean and dry your face thoroughly.
  2. Select light mode: Red only or combined red + blue.
  3. Wear the silicone mask, adjusting straps for a snug but comfortable fit.
  4. Place device close to skin—silicone usually hugs the face well.
  5. Session length: 15 minutes.
  6. Frequency: 3–5× per week or daily for 5–10 minutes if preferred.

Aftercare

  • Post-treatment, apply a hydrating serum, moisturizer, and daytime SPF.

4. M-300 Multifunction Silicon LED Red Light Tunnel Panel Wrap 

Setup

  • Charge via USB-C until fully powered; LED indicates readiness.
  • Use built-in control panel/buttons to turn on and select modes.

Usage

  1. Wipe area clean and dry thoroughly.
  2. Wrap the panel around the target region (e.g., arms, legs, neck) ensuring lights face skin.
  3. Choose mode based on your goals: skin tone, inflammation reduction, joint comfort.
  4. Session length: 10–20 minutes.
  5. Frequency: 3–4× per week; daily use for short periods is okay.

Aftercare

  • Apply soothing cream, lotion, or body oil post-session to lock in benefits.

General Tips for All Devices

  1. Start slow: Begin with shorter sessions (~5 minutes) and build up as tolerated.
  2. Maintain consistency: Use regularly—results typically appear after 4–6 weeks.
  3. Keep devices clean: Wipe down with a soft, damp cloth after each use.
  4. Use eye protection if your model doesn’t have built-in shields—avoid direct light into eyes.
  5. Monitor your skin: Discontinue if irritation or discomfort arises, then resume at a lower frequency.
  6. Store properly: Keep devices in a cool, dry place when not in use.